Low cost 1 hp (0.75 kW) VFD, three phase 230V/400V/480V 50Hz/60Hz for selection, sensorless vector variable frequency drive, RS485 enabled, strong overload capacity, manufacturer direct sale.
Delivery date: 15 - 30 days
1 hp variable frequency drive, three phase 50Hz/60Hz 220V, 230V, 240V, /380V, 400V, 415V, 480V.
||1 hp (0.75 kW)
||3 phase 230V /400V /480V AC ±15% (Optional)
||3 phase AC 0~input voltage
|Over load capacity
||150% of rated current for 1 minute, 180% of rated current for 3 seconds
Sensorless vector control;
||150% of rating torque at 1 Hz
|Speed control accuracy
||≤±0.5% of rating synchronous speed
||Digital setting: max frequency x± 0.01%;
Analog setting: max frequency x± 0.2%
||Analog setting: 0.1% of max frequency;
Digital setting: 0.01Hz
||Automatic torque boost, manual torque boost 0.1%~30.0%
|Interior PID controller
||Be convenient to make closed-loop system
|Automatic energy save running
||Optimize V/F curve automatically based on the load to realize power save running
|Automatic voltage regulation (AVR)
||Can keep constant output voltage when power source voltage varies.
|Automatic current limiting
||Limit running current automatically to avoid frequent over-current which will cause trip
||–10℃~ +40℃; VFD will be derated if ambient temperature exceed 40℃; each rise 1℃, the derate will be 5%
||5%-95%, without condensation
||≤1000m; VFD will be derated if above 1000m
|Impingement and oscillation
||Normal running:<5.9m/s2 (0.6g); Transportation:<15m/s2 (1.5g)
||–20℃~ +60℃; no dust, no corrosive gas, no direct sunlight
Tips: Can a VFD run on 400Hz?
Variable frequency drive (VFD) running on 400 Hz is not a problem as most VFDs can provide that output frequency but some may require a firmware modification to go that high. That high of an output frequency would also require a carrier frequency of at least 4 to 4.8 kHz as the ratio is required to be at least 1 to 10 but 1 to 12 is better. With that being said, the higher carrier frequency would require most VFDs to be derated a little bit.
Write your own review for 1hp (0.75kW) VFD, 3 Phase 230V, 400V, 480V